| |
Follow these instructions when installing and removing your Pool Spool 1. To remove a safety cover:Position the PoolSpool at one end of the pool. If the Safety Cover has a step-section on one end, it may be easier to start from the opposite end. 2. Next:Insert end springs into storage holes and start rolling the cover up. The springs and straps along the side of the Safety Cover may be folded back and rolled up while holding them parallel to the PoolSpool. If there is a step-section along the side of the Safety Cover, it may be folded back and the straps and springs folded back again towards the edge of the Safety Cover and held parallel to the PoolSpool while it is being rolled up. 3. To install a safety cover already on the PoolSpool:Reverse the above procedure.  4. To install a new safety cover:Spread it out right side up on a flat surface and position the PoolSpool at one end. If the Safety Cover has a step-section on one end, it may be easier to start from the opposite end. Continue as in 2. above. When the Safety Cover is rolled up, move it to the pool area for installation.
|
